During change of one Paramter Yesterday on a Aeotec-Smart-Switch ZW075 my Z-Wave was going Crazy.
So i tryed this Settings (111-113 = 3000) again with the Switch > Doesn’t makes something better. Have had contact with Aeotec-Support and got these settings:
Parameter 80 = 2 (report basic report)
Parameter 90 = 1 (enable threshold reporting)
Parameter 91 = 5 (report on change of +/- 5W)
Parameter 92 = 1 (report on change of +/- 1%)
Parameter 101 = 4 (report watt)
Parameter 102 = 8 (report kWh)
Parameter 103 = Disabled
Parameter 111 = 3 (only with threshold enabled to keep it from reporting too often)
Parameter 112 = 3600 (report kWh every 60 minutes or 1 hour)
Parameter 113 = 600 (should be disabled by default, otherwise 600)
With this Paramters Z-Wave is going to work, but sometimes got the Message that there is too much Traffic.
Played around with the given Parameters and have at the moment this settings:
Parameter 80 = 2
Parameter 90 = 1
Parameter 91 = 5
Parameter 92 = 3
Parameter 101 = 4
Parameter 102 = 8
Parameter 103 = Disabled
Parameter 111 = 30
Parameter 112 = 3600
Parameter 113 = 600
During the last Hours all works fine.
Update: HP23 with v10.0.0-rc.118
