Aqara FP300 with Matter!

[dsdevries]

@Maximino_Cantero_Mar ,

I just ordered my fp300 sensors, and I was wondering the same thing (in advance). Could you tell me what (advanced )settings are available on the device settings page? Maybe through a screenshot?
I was wondering if you are able to adjust the PIR sensor’s blind time for this.

I recently wrote this Tutorial about how to implement motion sensors and still gain full control on when en how to turn them off.

[HOW TO] Gain full control over Zone Activity using Motion Sensors (PIR) and Virtual Motion Triggers

Introduction This is not a guide on how to implement a specific use case, but rather a framework that will give you full control over zone activity. Many flows like turning on/off lights could be done much simpler. However, when my personal flows became more complex, I ran into a lot of caveats and quirks that caused me to rethink how I work with motion sensors. I came up with this system which allowed me to solve all the bugs I ran into and I would like to share it with all of you. The problem…

I want to replace my P1s by the fp300, but I want to keep the setup I already have with the virtual presence sensor in the middle to keep this control. I was wondering if updating this flow like the following will work and also solve your problem as well: (bear in mind, this is a modified screenshot as I did not receive my fp300 yet). Maybe someone can perform a test to see if this works?