I’m also looking for a solution for this. Not because I need the power measurements that bad. Just because time and again if I install one of the Greenwave Powernodes it holds on to the measurements at the time of installation. So it messes up my entire home measurements.
A while ago I managed to install the Tuya app using CLI. Still looking if someone can point me to a step by step guide on how to install this version 1.1.1 of Greenwave Systems on my Homey Pro.
Seems to be here… [HOW TO] CLI install method - Tutorials - Homey Community Forum
Now I only need to find the 1.1.1 as it is not in the Github repository anymore.
Ok, even though I read the whole thread I wasn’t paying attention. Found it and installed it.
Now I have my power measurements back again. Can I exclude the “overall” power measurement from Homey?
Because currently it holds the power of PN1 as PN1 AND as total of the power node. So for example on one of them currently I have the following:
Overall 52,3 Watt
PN1 52,3 Watt
PN2 25,2 Watt
PN3 1,1 Watt
PN4 15,9 Watt
PN5 41,9 Watt
PN6 39 Watt
And Homey shows a total of 227.7 Watt whereas this should be 175,4 Watt
