Hello,
I own two HomeyPro and while one has an Aqara P1 sensor fully integrated along with the Aqara official app installed (I can read many parameters including the battery status) the other Homey Pro with a P2 sensor (the matter version) does not integrate fully: for a start is not detected by the official Aqara app, though is recognized by homeypro but…I cannot set it’s parameters (such as blind time and so on) and most important the battery status is not readable.
Am I doing anything wrong or missing something??
Thank you for any highly appreciated help
1 Like
Ciao Stefano,
I can confirm that I also own an Aqara P2, which is currently not supported by the official Aqara app. However, I was able to integrate it using Matter.
Regarding the battery status, I haven’t found a way to read that information. But I’ve managed to configure the brightness and motion detection parameters directly in Homey Pro, as shown in the attached screenshot. I’ve checked and found that the blind time of the Aqara P2 is fixed at 1 minute and doesn’t seem to be configurable.
I hope this helps!
Marcello
1 Like
None of my Aqara Matter/Thread devices show battery status.
Hi,
not only Aqara. No Matter/Thread Device shows the battery Status.
I hope it is realized in HP Pro Firmware v12.3.0…
1 Like
