@wesley_w I’m following up with Athom support.
I have seen multiple reports on devices that stop reporting, but specifically for the sensor devices, I strongly doubt if the app, who only listens and does not actively communicate with the sensor, is the cause of no longer reporting devices.
In addition, I checked my diagnostics logs, but I can’t find any submitted by you (with your name as reference).
The v1.3.0 version of the app has just been released to the app store, adding support for the Aqara TVOC Air Quality Monitor.
For reference the default reporting behavior of the Air Quality Monitor:
Capability
Minimum reporting interval
Maximum reporting interval
Reporting threshold
Temperature
30 (s)
10800 (s)
0.2 degrees C
Humidity
30 (s)
10800 (s)
3% RH
TVOC
60 (s)
10800 (s)
20 ppm/m3
One note: the Air Quality Levels are currently based on the TVOC measurement results and Air Quality Levels specification. As a result the levels don’t correspond with the Air Quality 'leaves shown on the Air Quality Monitor. I’m clarifying with Aqara to get the levels specification matching the leaves shown or to get the ‘leaves’ reported by the the monitor.
@TedTolboom just wanted to give the feedback that I think you have a an admirable amount of dedication for this project. I really appreciate your work and support here!
Thanks
Roger
Adding support for one device, getting the questions for others… story of my… app
Not all Aqara H1 (wireless) switches are available yet.
Once they are available, at (my) hand and if my private agenda allows for it, I will add support for them.
I seem to be having issues which seem to be common with the sensors. I have the Aqara window and door sensors and about half of them go to sleep and never wakeup. I can re add them but then after some weeks they all go unresponsive. I sent a diagnostic report, but after reading think it has more to do with homey than with the app.
Hi,
I was thinking to use Aqara Vibration sensor for an additional notification for doorbell. But it looks like it cannot pick this change (pics). It is quite. rapid.
So:
is there a way to lower threshold so it will report alert?
Doesn’t the vibrationsensor respond when the ‘hammer’ hits the left iron?
There has to be a sensitivity setting in the device settings.
What about putting the v-sensor on top of the housing?
Here is a solution with a door sensor. I myself used a Neo Coolcam door sensor. Had to insert a (mini) AC/DC converter because else the sensor is triggered 50 times a second…
I used the small aquara button and soldered a wire in parallel of the push button. Connected this to the contacts of a relay and connected the relay in parallel to the “gong”. This works perfectly and never misses a “push”.