I recently ran tested one of my Fibaro Smoke Detectors to test a new flow attached to it. All worked fine. However now in Homey the detector remains in an alarm state. Dash shows the fire icon in red. Is there a way to reset the smoke detector/alarm mode?

Maybe this info helps: [image] Fibaro Smoke Sensor, won´t remove Smoke alarm trigger Devices First of all, the Fibaro’s should reset automatically, but if you remove the battery so silence the noise this will probably not happen. I cannot test this as I have no alarm, bu…

In the past a Fibaro Smoke alarm test would not trigger a Homey alarm (which is silly to me, but still). This recently changed, so it could be the Homey app was not tested for this situation. I would therefore also put in a ticket at the developer (Athom itself in this case).

Didn’t have a lot of time to test. Tried all suggestions but the only thing that helped was firing up the test alarm by long holding the button on the sensor again and waiting until it went off and sent the reset signal to Homey. Thanks!

Fibaro Smoke Detector - Alarm stays on

Devices

DirkG December 19, 2021, 7:47am 2

Maybe this info helps:

Topic		Replies	Views
Fibaro Smoke Sensor, won´t remove Smoke alarm trigger Devices z-wave	8	2022	August 21, 2021
Fibaro smoke sensor - How to remove smoke alarm warning Devices	5	3665	December 27, 2020
Fibaro Smoke Detector Rauch Alarm Zurücksetzen Fragen & Hilfe z-wave	7	1479	April 6, 2026
Reset fibaro brandmelder na melding Questions & Help	7	1452	December 14, 2025
My Wired Fibaro Smoke Sensor FGSS-001 keeps beeping Questions & Help	2	1333	April 25, 2022

Fibaro Smoke Detector - Alarm stays on

Related topics