Chronograph transition steps missing

[Edwin_D]

I see in another post that you have flows triggering every minute, starting timers checking device states on a periodical level and so on as in the below post. I would check your system load, as I would not be surprised if you use this approach more that Homey is too busy at times to execute the step at the right time.

Als zon een half uur schijnt, screens bedienen

Great flow. Very well thought. I wanted to let know my thought because everything can help to find the best for difficult situations. I use two Chronograph 10 minute timers. Brightness is measured by Fibaro sensor which is outside just above the two screens I have. If brightness is enough counter starts. If the brightness goes under setup value (cloud) it stops the timer and starts the other one. If it reach the 10 minutes the screens go up. If the brightness is constantly 10 minut…