Aqara magneetsensoren reageren niet meer

[Peter_Kawa]

Komt regelmatig voorbij.
Ik heb er zelf 12 van door t hele huis, zonder router devices. Werkt probleemloos.
Tips, truuks, advies (wel in t Engels):

Fixing disconnected Zigbee devices (without having to modify all flows)

Update: Today I Found another way to fix one. It was a Aqara Vibration sensor not reacting anymore, showing a bad route [?] in the Developer Tools - ZigBee After starting an Interview I started Pressing the button short on the device every ~3 seconds. These Devices have a lot of capabilities so need a lot presses before a complete interview is done but I guess after a couple of Presses it already was back in the network. Fixed!

WOOX R7060 smart garden irrigation control

Hi Hannes, seems like zigbee mesh and or zigbee/wifi related. Do you have enough router devices? What’s the distance to the nearest one? Athom zigbee advice If you run firmware v5 or higher: did you perform a zigbee reset after update to v5? (Be warned, all zigbee devices have to be re-paired, and flows need to be fixed) Zigbee network and channelnr info: https://tools.developer.homey.app/tools/zigbee Zigbee & WiFi frequencies interference. Interference check: http://ostgardh.se/wifi_z…