Aqara FP2, mmWave presence detection on WiFi

Devices
,
427

Hi,

An guide on how to add the Aqara FPS2 sensor to the Homey.

I just did my first attempt and these all the steps that I did. In my situation, i have an iOS-phone but no other Homekit devices.

  1. Download the Aqara Home-app
  2. Open the app
  3. Create an account and login
  4. Power up the sensor with a USB-C cable, it should flash yellow
  5. Add device in the Aqara-app and follow all steps. The Aqara-app automatically adds the sensor to the Home-app on iOS.
  6. Install Homekit controller on Homey
  7. Go to the device in the iOS Home-app and remove it.
  8. Go to the Homey and add it, the PIN is on the back of the device with a QR-code sticker.
  9. It’s added
  10. Go to the device in the Aqara-app and select that its being used as a presence sensor and follow the guide to configure the room.
  11. Go to the device in the Aqara-app and update firmware
  12. Optionally is to re-run the wizard.

Don’t forget to fix the IP’s of your sensors in your router!

7 Likes