Hi René,
Thanks for the swift testing and your reply.
Action 3-button remote
It looks like there was a mix-up in the command codes, while I kept the address at 0x00. To verify this, I installed the JTECH-8X8-H20 driver and performed a read-back using a Flipper. I found the following mappings:
- ON → J-Tech Key W (NEC command 0x46)
- OFF → J-Tech Output 8 (NEC command 0x15)
- TIMER 6H → J-Tech Input All (NEC command 0x18)
For the next (test) version, I’ll try to add a dedicated test remote driver with the action flow cards so all NEC options can be send.
Action 8-button remote
Since I don’t yet know the IR codes for the other commands, I wasn’t able to add those. However, I think this is still less confusing than reusing the HEMA driver for these remotes.
Thanks again for the feedback — definitely constructive and not taken as criticism in any way.
By the way, did you run into any issues when adding flow cards? Another user mentioned this, but I can’t reproduce it on my end.
Regards,
Stephan
