I use the VThermo app and it’s great! [image] VThermo Virtual thermostat and humidity controller However for my kitchen I’d like to exclude one temperature sensor: the one in the refrigerator. Is there any way to do this?

Hi, No, this is not possible. The device tiles are a part of the Athom design for the mobile app, and it’s only possible to show the target temperature.

I have a number of radiators controlled by Eurotronic Spirit thermostatic valves, but the built-in thermostat isn’t always reliable, so I was considering using VThermo instead. But how does VThermo work with radiator valves? Will it only set the valve to either fully open or fully closed, or can it…

I had the same question, and solved it (or avoided it) by putting the Spirit valves in a zone below the actual room, and setting the setpoint much higher than the setpoint actual requested. So, let’s say I want the bathroom to be 20 degrees and it is 18. In that case the heating is switched on and …

I have done something similar, but “manually”. My problem with the Spirits is that sometimes they keep the valve open, even if the room temperature is way above the target temperature. What I’ve done is creating a “watchdog flow” for some of the spirits, such that if the room temperature is more th…

Great app! Perhaps I’m stupid, but is it possible to control my heater when it heats or not based on the value in VThermo, instead of the default thermo in heater? As you can see below the average calculation in VThermo says heater of, but the heater itself is heating based on it’s own thermo. It’…

Thanks, It’s not possible without flows, I think. You can create two flows to adjust the target temperature fo the “Element - Nikes rum”, and that will turn the heater on and off. Flow 1: When: VThermo “Thermostat turned on” -> Then: set target temperature of “Element - Nikes rum” to a high value…

Hello I’m using vthermo. I set to update also the other thermostats and works. Is itnposwibile to add an offset to other thermostats? Offset value is only for the master

Why can’t vthermo start my sensibo AC? With vthermo I could use several temperature sensors to decide when to start/stop AC.

I cannot set target humidity to be the current humidity. The flow card gives an error. This should be possible no? Perhaps it’s because humidity is not an integer?

Yes, target humidity is an integer.

VThermo app

Apps

JPe4619 July 25, 2022, 12:45pm 104

Topic		Replies	Views
[APP][PRO] VThermo Apps app	361	19601	September 13, 2026
Heating Schedule App Apps	53	5730	June 2, 2022
[APP][Pro] Adaptive Thermostat - proportional heating from any sensor and any heater Apps	29	639	October 29, 2026
Aktuelle Temperatur von Thermometer übernehmen - Homey Heizungsplaner 🇩🇪 Deutsch (German) app	32	1303	April 21, 2024
[APP] Temperature manager Apps app , tools , devices , flow	32	4260	June 23, 2021

VThermo app

Related topics