Homey Pro v13.2.0 has been released to the stable channel.
Core
- Updates translations.
Zigbee
- Adds support for viewing routes in Developer Tools.
Z-Wave
- Official Z-Wave certified implementation.
- Updated Z-Wave chip firmware to version 7.21.6.
- Added SmartStart support. Devices can be added by scanning a QR code or by entering the DSK.
- Added support for controlling door locks and thermostat mode/setpoint from the default Z-Wave device.
- Added S2 multicast security support.
- S2 now grants all requested security keys (except S0) instead of only the highest.
- S0 can be enabled from the advanced settings when pairing a default Z-Wave device. Disabled by default.
- If security bootstrapping fails during pairing, the user is informed and the node will be removed.
- Improved handling of multiple decryption attempts for multiple security keys.
- Incoming messages with too low or no security level are now ignored.
- Associations are now validated against the destination node’s supported security and command classes.
- Return routes are correctly assigned when adding associations.
- When a node is removed from the network, corresponding associations on other nodes are also removed.
- Association group names are now retrieved from the node and shown in the device settings screen when not defined by the app.
- Battery devices are now correctly and faster put back to sleep when there is no more data for them.
- When changing settings of a battery device, an estimation is given for when the device will wake up. The result is shown in the timeline.
- When changing settings or associations on battery devices, the result is shown in the timeline after the device wakes up.
- If a device sends a Device Reset Locally notification, it is removed from Homey after verification.
- Added Inclusion Controller support.
- Improved Security S0 handling.
- Improved Transport Service handling.
Developer Tools
- Healing a Z-Wave node now also updates return routes for all association destinations.
- Added ‘Update Z-Wave Routes’ feature that performs a neighbor discovery of all non-battery Z-Wave nodes and assigns new return routes when needed.
- Added ‘Identify Z-Wave Node’ feature. The node will flash a light or make a sound.
- Testing a Z-Wave node now sends a NOP command instead of BASIC GET.
- The list of pending Z-Wave SmartStart inclusions is now shown and new entries can be added.
- When the Z-Wave network is reset, a Device Reset Locally notification is sent to nodes in the Lifeline group.
Erscheinungsdatum: 20.05.2026
