Gain wireless control of your home, keep your family safe, and become more energy aware with Develco Products’ wide range of wireless devices.
Connect your Develco Products devices with Homey and start living the smart life.
Use the Develco Products sensors and alarms to monitor and control your home. Keep track of your energy consumption and turn on/off your electrical appliances with the smart plug or the smart cable.
Thanks for the feedback.
For now we have decided to only implement alarm_battery and not the percentage based measure_battery; which does explain that the sensors will not show up in the battery monitor.
Following up on the parallel communication at the slack channel; likely the Zigbee chip (in general) didn’t initialize properly after updating the Homey (experimental) release. Unfortunately this is a known issue, but not related to a specific app (like Develco Products).
So no structural issue with the Develco Products app on RC9.
Do this app support the temperature sensors that are included in the smoke detectors? can we use the siren for other things? (The product should support this)
Problems with the smart cable, ask for rejoining, its within range, so no issue there. A restart of app fix the problem, but have to restart app every 10 minutes.
Would not recommend Develco for Homey at this moment. Problems with some drivers, and smoke detectors suddenly disappears from Network/Homey, and u have to repair/add units.
Yes, sorry for not specifying. Problem is v5 (sdk3). Humidity sensors has not been working since the update of the last beta, couple of months now. Today 2 smoke detectors just vanished from network, replaced batteries and re-added sensors to Homey and looks good so far, no warning concerning low battery, batteries was about 2 months old from store.
Hello. Just bought a Develco Smoke Alarm and the Window Sensor. Both connected just fine and the smoke alarm reports back data, but the window sensor does not report back temperature or contact alarm. Battery status shows “OK”.
Does anybody else have these issues? Is this a bug or is it anything i can/must do to be able to read data from the sensor?
