Creating a flow where a z wave push button control Wiz bulbs

I have a 4 channel z wave push button that`s working just fine fine with controlling a dimmer for some downlights.

But I have 6 wiz bulbs over my dining table and thought I could make use of the avaiable group switching and dimming the bulbs. All wiz bulbs are added to Homey.
When tesing flows it turns on/off and sets bulbs to preset light levels.
But it doesn`t work operating the switch itself.

I have a start card for the specific switch and group, and set to turn on that zone. Its created just for the six bulbs. But nothing happens at all. For dimming I`ve created simple dimming cards. Nothing happens.

To get help, you better show your flows, our cristal globe is a bit blury :slight_smile:

Here you are, pardon the language.

First of all, when you right-click on the divices-icon and then choose “Start from here”, do the bulbs then react?

The two ALL devices, show “enheter” is this “bulbs” in your language? Otherwise change them to Lamps or Bulbs (I’m also not native Englisch).

You can also test the push-buttons by making a temporarely push-message to your timeline for every button-output.

No, “enheter” is units or components. In this zone therr are only these bulbs.

Just tried to setup av push alert to my phone after pressing the start card, which is pressing the button on the switch. But nothing happens. If I test it through Homey I get the push alert, but not while operating the switch. When looking at the advanced settings under the switch it doesnt show any of the possible command classes avaiable in the switch. This goes for all my z-wave push buttons. Shouldnt it?

What is the branch and type of the z-wave pushbuttons?
How do these settings look like?
@Peter_Kawa , do you know these branches?

I have both Namron and Heatit Z wave buttons.

No, sorry.

1 Like

Think you better contact the app developer:
Having an issue with this app? Contact the developer by sending an e-mail.