Mill heaters Athom Homey support for for Mill WiFi heaters. Athom App Store: Mill WiFi | Homey Supported devices All Mill WiFi heaters should in theory be supported, but only AV1200WIFI and AV1000LWIFI have been tested. Flow cards The module supports all normal thermostat triggers, conditions and…

Hi, I am just getting timed out after 3000ms. Why can’t I add the ovens? [Screenshot_20230811_123126_Homey] [Screenshot_20230811_123057_Homey]

I dont know if you are using ios, but I am and my app version is now 4.6.2 - If you too are on iOS then open appstore and update your app. after the update, you should get an prompt to migrate to new servers. It may take up to 24 hours for all your devices to re-apear. or you can just repair them…

This app is very welcome indeed - since the mill app doesn’t work with HP 2023. However, as many other has commented, I also get a timeout at 3 sek/“network request failed”. I’m using generation one of the Mill AV600WIFI - maybe this panel isn’t supported (due to being gen 1)? The panels works ju…

Hello! I’m new to this, so please bare with me if my question is stupid. And please pardon my rusty english.:pray: I have used mill wifi heaters for some years. Now i am trying to get my brand new homey pro to “speak” with my mill wifi socket and my mill gentle air wifi (OIL2000WIFI3) I have found…

That is the wrong app, you should use Mill Heating. See my post above for the steps I took to install OIL1500WIFI3 (and later a OIL2000WIFI3).

Thanks for replying! :raised_hands:

Hey everyone! :wave: Looking at the recents posts in this topic, I want to thank you for all your feedback! :slight_smile: I took over this project from Glenn’s great work, and released a new app based on the old one. It seems like most of you already figured this out. As this is a new app, I have …

There is an issue with adding new Mill devices, I get this error: Cannot read properties of null (reading ‘length’) [image]

Hi, Is the Mill socket Wifi gen 3 supported? :slight_smile: or will it be at some point?

Got the new Homey Pro 2023 but i have problems with Mill ovens. Cannot get status update from ovens and not possible to adjust or use flows with them. When i run debug in App on Homey i get this error message “Error caught while refreshing state”. Seems Access token is refreshed ok from the debug lo…

[APP][Pro] Mill WiFi Heaters

Apps

Tirrazo August 11, 2023, 9:50am 206

Hi,

I am just getting timed out after 3000ms.
Why can’t I add the ovens?

Topic		Replies	Views
[APP][Pro] Mill Heating Apps app , devices , flow , homey-pro , advancedflow	247	10831	September 14, 2026
[APP][Pro] Miele@Home Apps app	43	4331	February 15, 2025
[APP][Pro] MELCloud (Classic), MELCloud Home & MELCloud Extension - Take control of your heat pump Apps app , devices , homey-pro	496	13785	September 14, 2026
[APP] SENZ-WIFI (nVent Raychem) Apps app , official	152	6014	April 13, 2026
[APP][Pro] Honeywell Evohome discussion topic Apps official	222	17458	November 7, 2022

[APP][Pro] Mill WiFi Heaters

Related topics