Hi there,
I am once again stumbling over an activation and deactivation issue with my 5 Indoor Pan & Tilt and my 2 S330 cameras. With Heimdal, I am using these as an alarm system, which is either activated manually of by geofencing.
However, during the holidays I became aware that the cameras are not properly turned on - here´s an excerpt of the flow:
This flow continues in that matter until all (in this case upper floor) cameras are turned on. However, only the first camera in the “row” is actually turned on, the 2nd and last one stays turned off, but without any error message being pushed to published to the timeline.
For the ground floor (where it´s 3 cameras), it’s always the last one/3rd camera in the “row”, which is actually turned on be the similar flow, also without and error message being pushed to published to the timeline.
As for the 2 S330, no camera is being turned on (same flow design).
It used to work, I just realized now that it doesn´t any more. Any suggestions?
Regards
