Hi @Adrian_Rockall,
I sent you new logs after and following your instructions. 
I donât know about your HA question, but the result was the same when I temporarily deleted the HA device.
Should I fully delete the YoLink integration in HA perhaps?
Hmm, looking at the new log it should all be working now as it connected to the broker successfully this time.
Could it be that it doesnât connect successfully after a reboot or something like that?
The error was
Connection refused: Not authorized
So, not sure why a reboot would cause that. Hmm, unless the old connection wasnât disconnected and there wasnât enough time for a timeout to disconnect it. The app does try to disconnected properly when it is shutting down, but that has been very flaky in the past where the app is killed too quickly for cleanup to complete.
Not sure if the cause was a reboot of course, but would sound logical to me.
Is there anything to do about this error?
Donât let Homey reboot 
I will investigate it but my Homey does reboot quite frequently due to alpha firmware updates and I havenât noticed that issue.
So, if you can figure out if thereâs a cause then let me know.
ATM, if that error occurs it doesnât try to reconnect, so I will also look into retrying the connection after 15 minutes. If it is a duplicate connection thatâs causing the problem then it should have timed out by then.
Any chance we could get the YoLink Smart Energy Monitor Plugs added ?
Thanks!
I can take a look if you are happy to test it for me as I canât use those devices in the UK.
Yes I would be happy to test
Thanks!
Would it be possible to control YoLink scenes/alarm settings from Homey?
Is the water depth sensor in the plans? Youâve covered everything else thank you
Iâm willing to test water shutoff valve
I use that water exhausted feature in IFTTT and would really appreciate in Homey.
I canât locate that in the API document. Could you send the Detected Log from the app settings page.
I canât locate that in the API document. Could you send the Detected Log from the app settings page.
@hurrybear and @Caesar, I have published a new test version with support for the Power Outlet and Water Depth Sensor.
I have no way to test these, so let me know if something doesnât work or if I have forgotten something.
Great thank you! How do I see test versions when I add a YoLink device?
find the app in the app store and then add test to the end of the url. Install the test version over the current version.
Do I have to be on same wifi as homey/yolink or can I be remote?
Iâm currently traveling and post installing the test version I donât see a new category when I add device. Trying the water leak sensor category returns no new devices found
Edit: I also noticed everytime I search for new yolink device my installed app version reverts back to stable version
