Hi,
I’ve publish a test version Tesla Power Connect | Homey with more logging. If you can install this one and do another “Diagnostics Report” I can hopefully figure out what going on.
Cheers
Rune
Good evening, I just installed the new version and the device is working again. Thank you and happy holidays!
Hi,
Sorry about that, could you please do a “Create Diagnostics Report”, you find it under cog-wheel in the App.
Rune
Done:
81852376-e043-4454-b2ef-0463aae99481
Thanks! Do you have more then one TWC ? If so are they in power sharing ?
Only one, but I see my old broken TWC still in the Tesla app. I have no idea how to remove that one 
So guess that has something to do with this issue?
Seems like it. Have you tried to uninstalled and installed the homey app ? That could potentially fix the issue.
Yes that fixed it! Thanks!
Hey community! 
Version 4.0.0 of the Homey Tesla Power Connect app is now available! Here’s what’s new.
Automatic Device Discovery (mDNS): The app now automatically discovers your Tesla Wall Connector on your local network, no more manually entering IP addresses. A manual IP fallback is available if mDNS fails.
New Capabilities: Three new sensors have been added: Signal Strength (WiFi RSSI), SNR (Signal-to-Noise Ratio), and Thermopile Voltage. The signal and SNR sensors give you a much better picture of your TWC’s wireless health directly in Homey.
Debug Visibility: A new “App Debug” section under Advanced Settings shows polling status, last success/error timestamps, and running counts, making connectivity issues much easier to diagnose.
Stability & Reliability: Polling is now resilient to transient network errors and will no longer silently stop after a brief network hiccup.
Performance & Memory: Memory usage has been reduced through differential settings updates and elimination of excessive discovery logging, along with a general code cleanup throughout.
Translations: The app is now available in 12 languages.
Feedback and bug reports are welcome.
Enjoy! 
Lost the connection with the tesla wall charger gen3.
Uninstalled the app and tried reconnecting but without result.
Connected to FW update 26.2?
Hi
Do a «Create Diagnostics Report» when you get the error, and I can try to fix the issue.
Rune
Just installed a new TWC Gen3 Wall Connector, then immediately installed your app on Homey. I was hoping for a card to control turning charging on/off. Unfortunately, unless I’m missing something I don’t see it. In fact, I don’t see any actual action cards. I see “When” cards, and “And” cards, but nothing under “Then”.
What I’m really wanting to do is be able to start/stop the charger from Homey Flows. What am I missing? FYI, I’m not using this with Tesla cars - have two Audi EV’s.
Hi,
Tesla has not released any API’s for controlling the TWC. So unfortunately until they do so, the TWC only provides data.
Cheers
Bummer. Right now, I can control the circuit that the charger is on using other means, but it’s turning on/off the circuit, so the charger then has to reboot when I turn it on again. It appears to be OK with that - same situation as a power outage really - but I’d rather be able to just manually tell the charger to start/stop from Homey.
I’m using the cars to dump excess solar in the afternoons when the house batteries are full. Otherwise, I only want the charger energized during EV charging rates overnight.
There is a homey app for Audi, seems to be in early development.
I was excited to see someone picked up the myAudi app for Homey. Thanks for that.
Now for the bad news - can’t get past the login. I tried logging out of the app on my phone and logging back in and accepting the terms and conditions. Still no good. Any ideas?
FYI, US Based, 2022 OG Audi etron
Suggest you post your issues with myAudi in the thread for the app,.
