I’m using the Z-TRM6 in power regulator mode to control a pipe heat cable without a temperature sensor. In this mode, the temperature is still shown in Homey and I’m only able to set temperature, not the effect in percent.
In want to change the power based on outside temperature read from Netatmo, but there is no flow for this. I see from comments above that Heatit is looking into this, which is good. I also need to turn the heating on and off using flows. This is not possible either.
Will it be possible to have the temperature gauge in Homey replaced by a 0-100% gauge when running in power regulator mode? The internal sensor has no meaning when controlling sources in another room.
