# Adding Trädfri GU10 bulbs **URL:** \ **Category:** Devices\ **Created:** [December 19, 2021, 8:03pm UTC](https://community.homey.app/t/adding-tradfri-gu10-bulbs/56877 "2021-12-19T20:03:25Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![Rudi\_Hendrix](https://sea1.discourse-cdn.com/flex025/user_avatar/community.homey.app/rudi_hendrix/32/31931_2.png) [@Rudi\_Hendrix](https://community.homey.app/u/Rudi_Hendrix)\ **Post date:** [December 19, 2021, 8:03pm UTC](https://community.homey.app/t/adding-tradfri-gu10-bulbs/56877/1 "2021-12-19T20:03:25Z")
While adding Trädfri GU10 bulbs, I noticed that the described method wasn’t working for me. Perhaps this was the case because they had been previously included. This is what worked for me… In my case I used a GU10 to E27 adapter to perform these steps close to the Homey. - Switch off the light - Let Homey search for the light - Switch on the light - Reset the light by switching it off and back on again 6 times. Then Homey will find the light. ---
**Author:** ![Geim](https://sea1.discourse-cdn.com/flex025/user_avatar/community.homey.app/geim/32/113356_2.png) [@Geim](https://community.homey.app/u/Geim)\ **Post date:** [October 28, 2023, 2:40pm UTC](https://community.homey.app/t/adding-tradfri-gu10-bulbs/56877/2 "2023-10-28T14:40:45Z")
Make sure while switching on and off, the on phase is shorter than 1 sec and the off phase is not too short. Wait after the sixth time and it should reset. In my case I waited not long enough in the off phase to reset the bulb. ---
**Author:** ![Rudi\_Hendrix](https://sea1.discourse-cdn.com/flex025/user_avatar/community.homey.app/rudi_hendrix/32/31931_2.png) [@Rudi\_Hendrix](https://community.homey.app/u/Rudi_Hendrix)\ **Post date:** [October 28, 2023, 4:13pm UTC](https://community.homey.app/t/adding-tradfri-gu10-bulbs/56877/3 "2023-10-28T16:13:25Z")
True, if you switch them on again too quickly most likely there is some sort of condensator in the bulb that holds the power for a bit and it doesn’t register as beings switched off. Still: just switching it off and on twice as indicated by the Homey app, doesn’t work